Diatone MAMBA F722S Flight Contoller
Diatone MAMBA F722S Flight Contoller gives racers an edge in competition. The latest F7 processing technology means you can focus on flying, not on the limits of your equipment. With a wide range of setup options and features, you can configure your FC however you’d like. It even has a dedicated LED controller and broken out LED pads for easy hookup (not included).
Specifications:
- MCU: 216MHz STM32F722RET6 32BIT
- IMU: MPU6000
- Baro: No
- OSD: BF OSD
- Blackbox: 16M Flash Memory
- UARTS: 6Set
- ESC Protocol: Dshot300/600/1200
- ESC Telemetry: RX6
- LED: Blue & Orange for FC Status, Green 9V, White 5V, Red 3.3V
- Controller: 4 Set 2812 LED
- Bluetooth: SpeedyBee APP
- Smartaudio: Yes
- RSSI: Yes
- Buzz: Yes
- Input: 3~6S Lipo (12.6~25V)
- VTS Protection: Yes
- BEC: 5V 2A & 9V 2A (Max 3A)
- FC Firmware: BetaFlight
- Target: MAMBA F722 Physical
- Mounting: 30.5×30.5mm, Φ3
- Weight: 6g total
Package includes:
1×Diatone MAMBA F722S Flight Controller
1×Diatone MAMBA F722S Flight Controller
Official diagram and documentation by Diatone.
*Important*
STM32F22 generates a lot of heat, therefore it is suggested to leave a space of at least 5mm at both sides of the FC with nothing covered to make sure of good air circulation to ensure it doesn’t overheat.
- Before soldering or mounting any flight controller, connect it to your PC to verify operation;
- Incorrect soldering techniques will damage this board. Please use the correct sized tip, temperature and technique;
- Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure.
Reviews
There are no reviews yet.