DIATONE V8.3 PDB with 12V 5V BEC & LC Filter

DIATONE V8.3 PDB with 12V 5V BEC & LC Filter

The DIATONE V8.3 PDB was created based on the V7.3 version but the direction of the ESC solder tabs where changed to a 90 degree angle. This PDB is quite convenient to use since it has soldering pads on both sides preventing you from dismounting the upper board when soldering is needed. Being small in size this PDB is easy to connect to any flight controller and due to its 4 layer PCB it guarantees that all ESCs work smoothly. With 2 sets of BECs one can connect servos, video transmitters, LEDs etc.
In addition to this, on the V8.3 there is an added ESC signal channel plug making soldering and wiring neater. The Hub also features a convenient solder bridge of various voltages for camera and video transmitters. Batteries may range from 3S to 6S LiPo.
The LC filter circuit uses a superior filter inductor, and a 47uf tantalum capacitor resulting in a low ripple of just 63mV.

Features:
Both-sides soldering ESC, convenient to use,
2oz copper & 4-layers PCB,
Low Ripple current,
ESC & Battery solder tabs in pairs,
Solder Bridges of various voltages for Camera & VTX,
DC/DC synchronous buck regulator, Efficiency is up to 95%,
5V & 12V Output LED indicators & Short circuit tolerant.

Specification:
Working Voltage: 3~6S LiPo (11.1-22.2V)
Output Voltage: 5V&12V
Output Current: 2A
ESC outputs: 4
Current output:4*20A
Size: 36*36mm
Weight: 5.5g
Mounting: 30.5mm / Φ3mm

Package Includes:

1 x PDB
1 x Cable