KISS 32bit Flight Controller V1.03
KISS 32bit Flight Controller V1.03 is Flyduino’s Flagship flight controller now updated with:
– changed bootloader solderpads to a press button
– changed USB Port type
A very sophisticated well planned and designed flight controller. Â Flyduino, with their own standardized firmware managed to reduce the headache required to setup your drone and get flying.
With this FC you simply need to select your frame type and you’re set as much of the configuration is already setup by flyduino’s engineers. All you may need is some PID tweaks if needed and some soldering skills.
Its important to note that other firmwares such as cleanflight can be ported to KISS 32bit Flight Controller V1.03.
Supported copter types:
– Tri
– Quad +/x
– Hexa +/x
Supported RX types:
– PPM Sum
– Spektrum Sat. (serial / DSM2 & DSMX)
– Futaba / Taranis SBUS
– Jeti ExBus
– Graupner SumD / SumO
– MultiPlex
– classic RX with single channel output
– STM32F303CCT6
– MPU6050
Weight: 4.6g
Mounting Holes: 3x3cm pattern, with 3.2mm holes (widely compatible)
Voltage: 2-6S
Driver for STM32F303CCT6
Normally you dont need to download any driver for the USB support.
Windows 7 8 and 10 care for this on their own after you connected the device.
The connection diagram / Pinout you find in KISS-FC GUI.
Manual (v1.05) for the KISS FC
Reviews
There are no reviews yet.